Rinnai Avenger 25 Plus Instructions d'exploitation télécharger pdf (Page 22)

Rinnai 20 Operation Manual

STANDBY/ON

STANDBY/ON Button

to ''STANDBY''

''STANDBY''

''TIMER''

''STANDBY''

OVER HEAT SWITCH

When the heater gets too hot during operation (for example when the filters or air outlet louvers are blocked) this

device turns the gas and or electric heating element off automatically. Remove cause of overheat (clean filters) allow

heater to cool, then re-ignite.

FUSE

The electrical circuits are protected by a fuse. When the fuse blows, the heater will not operate at all. The fuse must

be replaced by an authorised person.

FLAME FAILURE DEVICE

This device automatically cuts off the gas supply to the heater in the event of a gas failure. To restore the gas supply

to the heater, turn it off, and then follow the ignition procedure.

OXYGEN DEPLETION SAFETY DEVICE

If the oxygen level in the room drops below a pre-set limit, this device cuts the gas supply to the heater. If the oxygen

depletion device operates, turn the heater off, ventilate the room, then follow the ignition procedure to re-light. Heater

will not re-light unit room is fully ventilated.

TILT SWITCH

If the heater is knocked over, the tilt switch will cut the gas supply and or the power to the electric heating element.

The fan keeps running. To restore the gas supply, stand the heater upright, turn it off then follow the ignition

procedure. The tilt switch may also operate if the heater is jolted or picked up whilst in operation.

POWER FAILURE

In the event of a power failure or power cut, the gas valves will automatically close. After the power is re-instated

the appliance must be operated manually.

CHILD LOCK

SAFETY DEVICES

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Pas de commentaire

Rinnai Avenger 25 Plus Instructions d'exploitation Page 22